- Home
- Chimney sweeping materials
- Rotary chimney sweeping kits
- Complete sweeping kits
- Rotary chimney sweeping kit for drill, 17 mm PRO, 6 m
Rotary chimney sweeping kit for drill, 17 mm, 6 x 1 m
Rotary chimney sweeping kit for a drill: 6 flexible 17 mm rods of 1 m and a 450 mm nylon brush, to sweep 6 m of flue. The rod turns and the head knocks soot and tar off the flue wall. A drill adapter and a padded bag come with this DIZ Tools kit. On the drill: about 500 rpm with a nylon head, 800 to 1000 rpm with a chain head, both directions are allowed, never on hammer setting.
For round and square flues in stainless, ceramic and masonry. The flexible rods pass bends up to 45°. With 17 mm you have more choice: the black rod DZ102 for 90° bends and the heads DZ122 to DZ124. To sweep further, add single rods DZ101.
What should I watch with the drill? Use a variable-speed drill with an adjustable torque limiter. Never use it on hammer setting. Start slowly and stop at once if the head gets stuck. Slow down in fragile or older chimneys. Both directions are allowed, but preferably clean in one chosen direction. These speeds are recommended values and so not the mechanical maximum.
Can I sweep a chimney with a drill? Yes. The adapter goes on the drill or cordless drill. Never set it to hammer mode.
From below or from the top? Both. From below you go through the stove or the soot door, with the protective tube DZ193.
Does this replace the chimney sweep? No. Sweeping it yourself does not give you a sweep certificate. Check your policy for what your insurer asks.
- Stock: In stock
- Delivery time: Ordered before 3pm, delivered next day