Rotary chimney brushes and chain heads for power drills, for 12 and 17 mm rods. Nylon for stainless and flexible liners, steel cable or chain for masonry flues.
What speed do I use?
12 and 17 mm rods: about 500 rpm with a nylon head, 800 to 1000 rpm with a chain head, in both directions. These speeds are recommended values and so not the mechanical maximum.
What should I watch with the drill?
Use a variable-speed drill with an adjustable torque limiter. Never use it on hammer setting. Start slowly and stop at once if the head gets stuck. Slow down in fragile or older chimneys. Both directions are allowed, but preferably clean in one chosen direction.
Which brush for stainless?
A nylon brush. Steel cable and chain are not for stainless, flexible or rendered flues.
What about hard deposits in masonry?
Start with the steel cable head. For baked-on tar use the sharp cable head or a chain head.
How do I mount the brush?
The brush goes on a rod of the same size, the adapter on the drill. Never use the drill on hammer setting.