Rotary heads and brushes for drills, for 12 and 17 mm rods. Nylon for stainless and flexible liners, steel cable and chain for masonry flues with hard deposits.
What speed do I use?
12 and 17 mm rods: about 500 rpm with a nylon head, 800 to 1000 rpm with a chain head, in both directions. These speeds are recommended values and so not the mechanical maximum.
What should I watch with the drill?
Use a variable-speed drill with an adjustable torque limiter. Never use it on hammer setting. Start slowly and stop at once if the head gets stuck. Slow down in fragile or older chimneys. Both directions are allowed, but preferably clean in one chosen direction.
Stainless, flexible or enamelled flue?
Use a nylon brush: the universal 450 mm head, the 360° head or the double spiral. No steel.
Masonry flue with baked-on tar?
Use a steel cable head or a chain head. They are not for stainless, flexible or rendered flues.
Ventilation duct?
Use the soft duct brush or the duct cleaning head. For ducts with many bends there is the 6 mm flexible cable.
Does every head fit my rod?
Each head comes in a version per rod size: DZ1xx for 17 mm rods, DZ2xx for 12 mm rods. A few heads exist in one size only, as the name says.